Replies to This Discussion

Permalink Reply by Satellite Networks Motueka on July 8, 2016 at 9:42

The S7030 is not a Freeview approved STB so resetting to factory default wont fix it.

Maybe the manual below will help.

http://www.dishtv.co.nz/images/stories/User_Manuals/S7030PVR_Manual...

• ▶ Reply

Permalink Reply by Paul on July 8, 2016 at 12:47

Hi Roddy

Did you select New Zealand as your country after resetting ?

You probably need to change your LNB  type to the correct frequency .

Most common are 10750 & 11300 

Page 11 of the manual.

• ▶ Reply

Permalink Reply by Paul on July 10, 2016 at 12:27

S7030 Channel Update Instructions

Tuesday, 05 July 2016

To Load the channel data onto your S7030 you will need to follow these steps.

Unzip the downloaded file and place the files from the zip file onto your flashdrive.

Insert the Flash drive you have extracted the channel data files onto into the USB port on the receiver.

1. Go into the Main Menu
2. Move across to Channel Search and Select "DB Managment" and press OK
3. Select "Load from USB" and press OK
4. Select the file that corresponds to your LNB frequency and press OK
5. The unit will say "Please Wait" then "Load database successfully". Press Exit until you go back to your channels.

If you don't know your LNB frequency that's fine just select any file, if your channels have no signal after you have loaded the file just follow the steps again and select the other file.

Latest Channel Data

S7030PVR_ChannelUpdate.zip

Attachments:

• S7030PVR_ChannelUpdate.zip, 15 KB

• ▶ Reply

▶ Reply to Discussion