Is the rf output tuned or just a feed through of a raw rf signal which relies on the tuner in the tv?

Views: 84

Reply to This

Replies to This Discussion

I assume you are referring to the Veon 101 then the RF output plugs into the Antenna IN on your TV then use the Analogue tuner (if it has one) on the TV to tune it in .

RF looks ok on old crts but terrible on Plasma and LCD .

What model VEON box? Sat or UHF?

Hi Biggles.
It is a Sat version 101. What I am trying to do is use a separate UHF tuner on this output for input to a Mac.
I tried using the Mac UHF tuner but the it does not detect any output.
Any suggestions?

Any RF output from the VEON 101 would be analogue so the Mac tuner would need to be analogue to find the VEON's output channel.

Reply to Discussion

RSS

Connect With Us!

Latest Activity

Karyn Jensen replied to Karyn Jensen 's discussion Dish S7070
"Definitely S7070 :-)"
7 hours ago
Paul replied to Karyn Jensen 's discussion Dish S7070
"Is it a S7070 or S7070r ?"
8 hours ago
Karyn Jensen replied to Karyn Jensen 's discussion Dish S7070
"Thanks for the info. The signal and strength are both showing 0% when normally it shows at about 78%"
9 hours ago
Biggles replied to Patricia Harkins's discussion Which Freeview recording box?
"HTPC = Home Theatre PC. Usually a low cost small footprint silent box. No fans to make noise while…"
14 hours ago
Biggles replied to Karyn Jensen 's discussion Dish S7070
"Check your signal strength in the Tuning Menu too. My Sat receiver shows around 56% signal and 40 -…"
14 hours ago
Patricia Harkins replied to Patricia Harkins's discussion Which Freeview recording box?
"Thank you so much for the advice, appreciated. I am not familiar with HTPC but shall look into it.…"
14 hours ago
Biggles replied to Patricia Harkins's discussion Which Freeview recording box?
"Never had any problem with my Panasonic recorders. On the other hand the DishTV and others seem to…"
14 hours ago
Paul replied to Karyn Jensen 's discussion Dish S7070
"The Lnb may have started to drift , try doing the below. S7070 LNB Drift    To…"
16 hours ago

Upcoming Works

© 2017   Created by Bel.   Powered by

Badges  |  Report an Issue  |  Terms of Service