Hi, I have a Super Net 4200S. What do I do to tune into Prime?

Views: 196

Reply to This

Replies to This Discussion

Do a manual channel search for 12519. Prime, Bravo+1 etc are on one of the Sky Transponders.

http://www.digitdirect.co.nz/store/Installation-Guide-Supernet-4200...

http://www.lyngsat.com/Optus-D1.html

However if you did an Auto search for FTA it should have been found during initial setup.

P.S. Your profile is a bit confusing. You say you receive Freeview HD via UHF yet you are using a Satellite STB (Supernet 4200S) which won't work on UHF. It needs a satellite dish and Satellite Freeview is only SD not HD.

You are right. We have both but must only be connected to a satellite dish. So what frequency do we programme for Prime?

As stated in the previous reply. 12519

Reply to Discussion

RSS

Latest Activity

Biggles replied to John Kirkbride's discussion TV 3 6PM News Recording Problem
"My Panasonic did the same recently and has also done so occasionally in the past. Was set to record…"
22 hours ago
Cliff Baker replied to Jared's discussion tvnz ondmend
"I think the previous firmware was actually 3.925 from October 2017 so you hadn't missed out on…"
yesterday
John Kirkbride posted a discussion

TV 3 6PM News Recording Problem

Have a couple of Panasonic DVR's and have had recurring problems since 2013 with recording the news…See More
yesterday
David B replied to Jared's discussion tvnz ondmend
"It's a 43W800C"
yesterday

Connect With Us!

© 2018   Created by Bel @ Freeview.   Powered by

Badges  |  Report an Issue  |  Terms of Service