If you have the hills hsmx200 receiver then i am afraid it will not work with the new prime transponder update. I rang the hills help line after trying many times to update as per the instructions on…Continue
"Did you use these instructions ?
Should work with a 11300 LNB
Tested numerous times on a Hills HSMX-200 Satellite Receiver with latest firmware v1.23
Reset Factory Default
1. Press Menu
2. Use Right arrow key to select System
3. Use Down arrow key…"
"I've been trying to get 12519 to be scanned on one of these boxes but no luck.( LNB 11300)
The stupid thing is that in the one part of the menu that you can add a transponder frequency of 12519 you are unable to scan it. When you go via the…"
"Well paul , that sentance just proves to me how exceptionaly helpful you have been , obviously going out of your way to help people in need of some help. I am sure your elderly neighbours are also very grateful for your help. That is a fine thing to…"
"Brilliant mate , it works !!. All channels are now tuned. I have posted a full thank you message on your profile page .
Exceptional efforts on your part sir, thank you so much for your time and expertise mate, truly fantastic."
Back from my holiday, and my goodness you guys have been very busy trying to sort out this retuning issue!.
I have just retuned according to Pauls instructions and i now have all channels again. Fantastic!!.
I want to thank you all…"
"The transponder table lists the TP frequencies that we can pickup in NZ. I have experimented with removing all TPs except 12456, 12483, & 12519 then doing a full re-scan and Four+1, Prime and Edge are collected ok along with…"
" it shouldnt be looking at those frequencys and symbolrates, are they listed in the transponder menu itself?
if you delete all transponder data except 12456 H 12483 H and 12519 H does it still look for them?
those look to be the verticals…"
"Just looking thru the log, I've noticed the following (by adding the IF output frequency and the LNB local oscillator frequency
During the initial scan, the frequencies 12456, 12483, 12644 & 12707 work out correctly when adding the IF &…"
"I have attached a log file taken from the internal serial port of the HSMX200, if anyone wants to analyse this and see if they can spot a problem:
Starts after a Set Defaults
Starts with a log of a normal scan, using Auckland as the region
"I have theory that the ISSUE is with the NIT info on SKY home transponder 12519 H
If someone with pci or usb satellite tuner card can take a look at the NIT info data, quite often NIT info is junk or full of errors. As in wrong freqs