Hi there,
I’ve installed Freeview through my smart tv and through a receiver on my other tv. I’ve set up Freeview using auto scan and only got the TVNZ channels. What do I do now in order to get the rest?

Thanks

Views: 234

Reply to This

Replies to This Discussion

Check your signal strength/quality. If you are only receiving the TVNZ MUX and no others then you probably have an antenna/cabling problem and the other MUX are below the minimum signal strength required for reception. TVNZ MUX is probably just above the minimum. What sort of antenna do you have  and how have you split the cable between the two receivers? With weak signals quite often a Manual Scan will find them while Autoscan will bypasses them

F

Reply to Discussion

RSS

Latest Activity

Amanda replied to Amanda's discussion Dish tv
"Thank you very much have just changed settings and it is working again once again thanks"
9 hours ago
Alison posted a discussion

Not able to watch OnDemand

Can log on to OnDemand and can select show and episodes I want to watch but when I click play I…See More
16 hours ago
John Baird replied to Amanda's discussion Dish tv
"As Biggles said ,but Dish Tv boxes try both LNB frequencies at set up. What is more likely is that…"
yesterday
David Lipscombe replied to Taylor's discussion How do you set up transonic as in all the cords. Forgotten how to.
"here are 2 shots that may help you for your set up"
yesterday

Connect With Us!

© 2018   Created by Bel @ Freeview.   Powered by

Badges  |  Report an Issue  |  Terms of Service