As per the title when I try to install my "flash as" super clever A2 it is not finding ANY channels .

The dish and LNB was working and still works when I plug  the old box back in.

The YV is a Sony Bravia.

Where do I start please

Views: 518

Reply to This

Replies to This Discussion

Have you tried changing the LNB frequency between 11300 and 10750?

When you do a scan for channels it goes through all the frequencies for the LNB and I don't see anywhere under the settings that you can make it 1 or the other.

I think the A2 accommodates the drifting LO on the old sky LNBs. Its got to be either a faulty LNB or faulty box. Have to tried a power reset on the A2? I would be ringing DishTV.

 

Ok....so LNB is 5 months old , so would hope its not that and it works ok with the old system, as for a power reset do you mean turn it off on back on ?? cos its been of and  on several times.

It is not a sky dish or LNB the dish is much larger than a sky dish , on the old box the picture is great  steady and sharp with no noise.

Thank you. 



Satellite Networks Motueka said:

I think the A2 accommodates the drifting LO on the old sky LNBs. Its got to be either a faulty LNB or faulty box. Have to tried a power reset on the A2? I would be ringing DishTV.

 

It could be an oddball LNB that's not supported by the A2. The LNB LO frequency should be written on the LNB. 

Thanks for your suggestions , what I found was the old setup was motorised but hadn't been working for some time , the dish was aligned and the LNB was fine, we bypassed the motor and bingo great signal.

I replaced the cable top to bottom for good measure as it looked quite old.

Thanks

Allan Innes said:

Ok....so LNB is 5 months old , so would hope its not that and it works ok with the old system, as for a power reset do you mean turn it off on back on ?? cos its been of and  on several times.

It is not a sky dish or LNB the dish is much larger than a sky dish , on the old box the picture is great  steady and sharp with no noise.

Thank you. 



Satellite Networks Motueka said:

I think the A2 accommodates the drifting LO on the old sky LNBs. Its got to be either a faulty LNB or faulty box. Have to tried a power reset on the A2? I would be ringing DishTV.

 

Thanks for your suggestions , what I found was the old setup was motorised but hadn't been working for some time , the dish was aligned and the LNB was fine, we bypassed the motor and bingo great signal.

I replaced the cable top to bottom for good measure as it looked quite old.

Thanks



Josh @ Freeview said:

Great to hear Allan! 

Thanks mates! This really helped me a lot

Reply to Discussion

RSS

© 2021   Created by Bel @ Freeview.   Powered by

Badges  |  Report an Issue  |  Terms of Service