freeview tuning

we have just moved into a new place 2 mins up the road & when i plugged the freeview sat box in, it came up with no signal..i have the sat dish plugged into the correct plug, the tv is picking up the freeview box but i just can't tune it in.we are in Hamilton.i am using optus d1 sat. i read somehere that the low & high MHZ should be set to 10750.and still no good.am i missing something? do i need to change the start & end Frequency? just trying to $70 for the guy to come out & fix

Did this help? Click to mark!

0 members promoted this

▶ Reply to This

Replies to This Discussion

Permalink Reply by Biggles on September 26, 2017 at 11:44

Your LNB may be 11300mhz, not 10750. Try 11300 instead.

▶ Reply

Permalink Reply by forumuser on September 26, 2017 at 11:46

Hi Wayne

It could be the LNB settings you need to adjust there are two common frequencies 11300 and 10750 you could have either so if you toggle either freq and see if you get a signal as your box would have the previous settings from your last satellite dish.

▶ Reply

Permalink Reply by Paul on September 26, 2017 at 12:32

try 10745 or 10742 the LNB my have drifted ..

wayne morris said:

Josh Hill ✔️ said:

Hi Wayne

It could be the LNB settings you need to adjust there are two common frequencies 11300 and 10750 you could have either so if you toggle either freq and see if you get a signal as your box would have the previous settings from your last satellite dish.

I tried both & it still came up with tuning failed

i reset to factory settings last night hoping it would work