Devices covered in this post: Alkris, Orton, Satlink and ZeaTek or any receiver that shows the following similar display by pressing the menu button.

This is the Menu display: Check to see if you have the same type or display if you do then follow the next steps with photos! If not then you may be able to follow the instructions but display may differ. 

Step 1
On your remote press Menu and then using the arrow keys navigate to the Installation menu, 

Use the right arrow key to select Installation in the light blue box (See picture above)

-------------------------------------------------------------

Step 2
On your remote press the yellow button (Edit TP)

-----------------------------------------------------------------

Step 3
On your remote press the green button (Add)

-----------------------------------------------------------------

Step 4
The above screen shot shows the stage: 

A highlighted box around [0_MHZ] is where you will add the TP Frequency  use the remote to enter: 12519

Use the bottom arrow key to go down one to Symbol Rate and enter 22500

The level and quality signal should pick up both yellow and orange lines that may change levels. 

Press the RED BUTTON 

------------------------------------------------------------------

Step 5
The above screen shot shows what should be selected

Use the arrow keys to select the correct options as above. 

Once your menu shows the same then press OK to search

The unit will then scan and obtain the channels. 

Move the channels as to your manual guide. if you wish, they will be located at the bottom of the channels