Devices covered in this post: TOPFIELD TF6000Fe and VESTA or any receiver that shows the following similar display by pressing the menu.

This is the Menu display: Check to see if you have the same type or display if you do then follow the next steps with photos! If not then you may be able to follow the instructions but display may differ on Strong units. 

Step 1
On your remote press Menu  

Then select Installation   

------------------------------------------------------------

Step 2
Select SAT/TP Edit (highlighted in light blue above)  

------------------------------------------------------------

Step 3
Select Add New TP

------------------------------------------------------------

Step 4
A box will pop up (like above) 

On your remote enter in 12519

And for symbol rate enter in 22500 

Pol: Horizontal 

Press OK

Press Service Search 

------------------------------------------------------------

Step 5
Check the following Settings:

Search Mode: AUTO
Network Search: OFF
FTA/SCRAMBLED: FTA 

PRESS START SEARCH

It will now search for Channels, Save anything if required and exit out of the menu and return to the Channels. 

Channels will be on the bottom/last of the channel list so have a look by pressing the OK  button

You are Done.

------------------------------------------------------------