Tags:
Replies are closed for this discussion.
Are you on firmware 1.23 ?
There are some instructions here, I don't see it why it shouldn't be able to load the new T.P
Those are the original instructions for moving to Prime on the now OLD frequency 12706 H
There are instructions here you should be able to follow
https://drive.google.com/folderview?id=0Byb0inAecDEJQjBjcllxeE1HRG8...
just use the t.p data as
Change the following (Type in using numbers)
Frequency 12519
Symbol rate 22500
Polarity should be H for Horizontal
Click the folder where it says archive
Click where it says tip - add trackside
follow instructions, but use 12519 H as the frequeny you add
Try a factory reset, choose Auckland as region
Then try the above again
The guy in the other thread has it going. Hills is just trying to flog users a new unit so they dont have to deal with supporting it.
This thread
maybe graham can post photos
http://freeviewforum.co.nz/forum/topics/loss-of-prime-the-edge-with...
See Network Status page for updates.
Freeview On Demand Changes Read More Here
© 2024 Created by Bel @ Freeview. Powered by