Veon tv connected to uhf outdoor aerial - not the only TV using aerial, run off splitter.

Hi group,

I have the above tv running off the uhf aerial, and there's 2 other tvs running off the splitter, other two tvs are fine.

When tuning the dtv freeview chanels, it's only finding Chanel 1, 2 ,1+1, 2+2, Duke and Duke +1. It's actually finding 12 channels, but possibly they are double ups, but only shows the 6 channels in channel manager.

In the past I'm sure it had found around 18 or more channels.

Any ideas

Cheers

Pete

Did this help? Click to mark!

0 members promoted this

▶ Reply to This

Replies to This Discussion

Permalink Reply by David Lipscombe on December 29, 2021 at 17:34

Have you tried disconnecting the other 2 TV's and then tune in the Veon to see if that will pick up all the required channels and then reconnect the other 2 to find out what will happen .

And does you splitter box have power running through all the ports ?

▶ Reply

Permalink Reply by Pete on December 30, 2021 at 0:16

Hi,
I will have to check the splitter to see if it's a power pass on all ports one.
I haven't tried unplugging the other 2 tvs yet, I will do that, I'll post back after doing so.

Cheers
Pete

▶ Reply

Permalink Reply by Pete on December 30, 2021 at 15:38

Hi,

This is a photo of one splitter, I'm thinking it's a wrong type of one for my application? As no power pass on all ports?

Cheers

Pete

▶ Reply

Permalink Reply by Pete on December 30, 2021 at 15:38

▶ Reply

Permalink Reply by willis on December 30, 2021 at 18:09

The red lines mean power pass on this splitter
Tune in all TV's directly off aerial then put them where they're supposed to go

▶ Reply

Permalink Reply by Pete on December 31, 2021 at 9:11

I tried a tune in with splitter disconnected, found 12 channels, only displayed 6 channels again.

Is there a channel memory wipe, if so what is the full procedure please.