We have just purchased a Samsung flat screen TV, model UA43MU6100S with built in dual UHF and Satellite tuner. We are attempting to pick up Freeview channels via satellite but Auto-tune picks up no channels, resulting a message - No Signal. Have checked using our old GOG decoder box and this picks up Freeview channels fine. Have attempted the fix below as posted by Jake Funeki on 2 June 2014, which tells us we have signal strength of 67%, but as soon as we run Auto-tune after inputing the settings below it results in the outcome described above - No signal. It is quite an old dish; could be the problem (but GOG box works fine so don't see how the problem can be the dish. Frustrated - any advice would be welcome
-> Aerial = Freeview Sat
-> Channel Settings
->-> Country = New Zealand
->-> Satellite System (enter your PIN - default code is 0000)
->->-> LNB Power = On
->->-> LNB Settings
->->->-> Satellite = Optus D1 160E
->->->-> Transponder = 12483 MHz, H/L
->->->-> DiSEqC Mode = Off
->->->-> LNB Type = Single Oscillator
->->->-> LNB Oscillators = 10750 Mhz
->->->-> Tone 22 kHz = Off
try LNB Oscillators = 10745 Mhz (LNB may have drifted)
or LNB Oscillators = 11300 Mhz (you may have a 11300 LNB)
Paul bet me to it!
You might have a 11300LNB which you will need to set in the TV settings.
If you need to double check, plug your GOG back in and see if you can see in the settings what your LNB is set to?