"No signal" on Satlink 2700

Hi everyone... Help!

I've had a Satlink 2700 working on an old 29" Transonic CRT TV for 6+ years. It ran a scart plug to the TV, and lead from the LNB line-in to the TV socket (good for both VHK/UHF & sat. dish).

Now I have upgraded to a flat screen, but cannot get a signal no matter what I do. The Satlink menu displays on screen & confirms there is "no signal". I am now using AV cables to connect the STB to the TV and obviously have the TV in "AV" mode.

What am I doing wrong? Thanks for any suggestions.

Did this help? Click to mark!

0 members promoted this

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Paul on January 9, 2014 at 20:17

have you tried using the cable from the other receiver that connects from the wall to the lnb in on the back of sat link , it sounds like a poor connection or broken wire.

Permalink Reply by Allen on January 9, 2014 at 20:36

Tried another cable and it made no difference even after a rescan (single). I did notice momentary part pixilation onscreen before it disappeared and the "No signal" message appears.

I also notice that on the "Satellite" page all the properties of the Optus D1satellite are at "0".

Permalink Reply by Paul on January 9, 2014 at 20:49

select the lnb type and then change to user and change to 11300 manually if possible.

Permalink Reply by Allen on January 9, 2014 at 21:57

"Standard"/"user"/"universal" all are changeable. I think user & universal are dual frequency.

Tried that & didn't seem to make a difference,,,,

Permalink Reply by Paul on January 9, 2014 at 22:03

when doing a single satellite scan try a blind scan.

Change scan type to blind (maybe called detail) and network search to On

Permalink Reply by Allen on January 9, 2014 at 22:59

Is blind scan same as auto scan? Tried that.... no difference. I am still getting momentary part formation of a picture before it reverts to "no signal"

Permalink Reply by forumuser on January 10, 2014 at 11:44