Search Results (9,502)

Discussions	Replies	Latest Activity
"Thanks Paul, That was the problem! Found my channel now.. " Stef Jongkind replied Nov 24, 2013 to Second LNB	3	Nov 24, 2013 Reply by Stef Jongkind
"You could try updating the firmware and hope it deletes the password. or Try asking…" Paul replied Nov 25, 2013 to Homecast HT9200DTR problems	3	Nov 25, 2013 Reply by Paul
"Cut and paste below from Dish TV Support Fuzzy or Blurry picture The steps to correc…" Paul replied Nov 19, 2013 to Unclear writing or text	4	Nov 20, 2013 Reply by Biggles
"What does a Satelite cable look like? I've got two cables. One with s smaller pin in…" Elijah Pue replied Nov 21, 2013 to HOW DO I TUNE MY SATLINK 2700 TO A UHF AERIAL?	7	Nov 22, 2013 Reply by Mike G
"I switched them around and no difference" Russell Dean replied Nov 23, 2013 to No Signal message	11	Dec 1, 2013 Reply by Tyren Mulder
"Try turning the 22khz to on for the second lnb then scan Optus D2. " Paul replied Nov 24, 2013 to Second LNB	3	Nov 24, 2013 Reply by Stef Jongkind
"Have you tried a cold start? i.e. Disconnect from power source, wait about 30 secs a…" Biggles replied Nov 25, 2013 to Homecast HT9200DTR problems	3	Nov 25, 2013 Reply by Paul
"on the LNB 2 make sure the 22 kHZ is Off , if you are using an old sky dish." Paul replied Nov 25, 2013 to Service not collected during tuning	14	Nov 27, 2013 Reply by Alex
"Ok, I'll try that tomorrow. Bit late to go over there again tonight! " Alex replied Nov 25, 2013 to Service not collected during tuning	14	Nov 27, 2013 Reply by Alex
"Try to change the LNB frequency to 11300MHz and then try to tune the channels. It do…" Mike G replied Nov 27, 2013 to Service not collected during tuning	14	Nov 27, 2013 Reply by Alex