Hi folks I had purchased a S7070r for my satellite dish, its been working perfectly for over 5 years until suddenly yesterday it was showing no signal-check cable or dish. I ran the factory reset and tried to run the auto tuning. Just says tuning failed. Can anyone reccomend what to do. i am no expert in these things so might have to be a bit non technical with me
thanks

Views: 102

Reply to This

Replies to This Discussion

Could be the Satellite Dish and the LNB, you could have a look at these articles: 

https://freeviewforum.co.nz/forum/topics/freeview-satellite-adjusti... 

Otherwise this could be that your unit is faulty, but most times the LNB may need replacing,.

Josh

Reply to Discussion

RSS

LATEST:

FREEVIEW ONDEMAND on DISH TV
11th September 2019 -UPDATED-

Firmware updates released for S8100 and S8300 boxes, please follow updates here

Connect With Us!

Be a part of the New Zealand Freeview Community!

Welcome to your Freeview Forum!  This is the online home for all Freeview viewers, retailers, manufacturers and installers. It's a place where you can find help, share advice, tips and your know-how to help another fellow "Freeviewer" out.

How do I get started?

1. Begin by signing up for Freeview Forum here.  Sign up is simple, fast & free, all we ask is that you abide by a few simple guidelines.

2. Once you've signed up, you'll be able to:

What details should be included when asking for help?

Including key details will help the community help you.....

1. What your coverage is (check by entering your full address here).

2. What antenna you're using (indoor of outdoor UHF aerial, or satellite dish).

3. What brand & model your device is.

4. What channels or programmes you're having trouble with (if any).

5. And of course - as many other details as you think would be relevant.

© 2019   Created by Bel @ Freeview.   Powered by

Badges  |  Report an Issue  |  Terms of Service