Have a problem with my daughter's decoder. I disconnect my decoder (Veon 101) and replace it with hers. Run through a scan and pick up 15 TV stations and 12 radio stations. During scan signal level is 80% and quality 98%. After completion of scan, the result is saved. When trying to now watch TV, get  "no signal" on the screen. When I put my Veon 101 back, no problem. (Incidentally, I think the Veon 101  and the Dish TV s7070r are basically the same thing with different names). Any help would be appreciated please.

Views: 268

Reply to This

Replies to This Discussion

Followed some of the advice on this forum and did a "Factory Default" reset, tried again and victory is nigh, all works ok now. Thanks to the Freeview Forum for the good work you do. Best regards to all.

Reply to Discussion

RSS

Latest Activity

Graham Syder replied to Graham Syder's discussion is there UHF in Puponga?
"Excellent feedback guys, I'm off over there for the weekend. I don't have a mast to…"
15 hours ago
Satellite Networks Motueka replied to Graham Syder's discussion is there UHF in Puponga?
"Willis is right and you dont need a high gain antennae.The coverage map is so flawed. There is no…"
yesterday
Biggles replied to Graham Syder's discussion is there UHF in Puponga?
"Well it does according to it's coverage map. East side of Arapawa Is shows good reception…"
yesterday
willis replied to Graham Syder's discussion is there UHF in Puponga?
"signal probably Mt Campbell as kaukau doesn't go west"
yesterday

Connect With Us!

© 2018   Created by Bel @ Freeview.   Powered by

Badges  |  Report an Issue  |  Terms of Service