Devices covered in this post: Digistar or any receiver that shows the following similar display by pressing the menu button.

Taken from a Digistar 860U

Step 1

On your remote press Menu 

Use the arrow keys to locate the "Gear Icon" as seen above and then select "TP Manager"

-----------------------------------------------------------------------

Step 2

On your remote press OK (ensure the orange box is on "Add Transponder")

--------------------------------------------------------------------------

Step 3

On your remote press the  YELLOW BUTTON 

--------------------------------------------------------------------------

Step 4

A dialogue box will pop up (above) enter the following information:

Frequency: 12519
Symbol Rate: 22500

Polarity: H


then go down to SAVE  and press the OK button on the remote

(It may vary but once you save it may ask you to scan, Proceed with the scan if it does) You will get your channels (Check the bottom of the channel list) IF There is no scan then go down to the next step and continue:

--------------------------------------------------------------------------

Step 5

You will be returned back to the screen above, 

FIND AND LOCATE THE 12519 as seen in the highlighted above, it will vary on your receiver but scroll down the list to find it. 

Once you find the 12519.... Then Press the RED BUTTON to scan. 

Done!

--------------------------------------------------------------------------