Hi there,
I’ve installed Freeview through my smart tv and through a receiver on my other tv. I’ve set up Freeview using auto scan and only got the TVNZ channels. What do I do now in order to get the rest?

Thanks

Views: 396

Reply to This

Replies to This Discussion

Check your signal strength/quality. If you are only receiving the TVNZ MUX and no others then you probably have an antenna/cabling problem and the other MUX are below the minimum signal strength required for reception. TVNZ MUX is probably just above the minimum. What sort of antenna do you have  and how have you split the cable between the two receivers? With weak signals quite often a Manual Scan will find them while Autoscan will bypasses them

F

Reply to Discussion

RSS

© 2019   Created by Bel @ Freeview.   Powered by

Badges  |  Report an Issue  |  Terms of Service