We have the above Free view Box and are unable to record for some reason.

We are able to set programs in as a Series Link but on the Record List - it stays blank ie no start or end time and no program name as before.

Any ideas most appreciated.

Views: 115

Reply to This

Replies to This Discussion

Have you tried resetting the device? a reset may clear any issues with the guide and starts the device as fresh, alternatively you can switch the unit off and on and try again. 

Kind Regards

Josh

Hi Josh

Thanks for replying earlier.  Have been away hence delay.

I reset the Homecast to Factory Settings and seems to be all ok except that some programs will not allow me to set 'Record' and are showing an error reading "Code-2 error' - Any ideas re this?

Thank you, Jenny

Reply to Discussion

RSS

Latest Activity

Graham Syder replied to Graham Syder's discussion is there UHF in Puponga?
"Excellent feedback guys, I'm off over there for the weekend. I don't have a mast to…"
2 hours ago
Satellite Networks Motueka replied to Graham Syder's discussion is there UHF in Puponga?
"Willis is right and you dont need a high gain antennae.The coverage map is so flawed. There is no…"
14 hours ago
Biggles replied to Graham Syder's discussion is there UHF in Puponga?
"Well it does according to it's coverage map. East side of Arapawa Is shows good reception…"
14 hours ago
willis replied to Graham Syder's discussion is there UHF in Puponga?
"signal probably Mt Campbell as kaukau doesn't go west"
17 hours ago

Connect With Us!

© 2018   Created by Bel @ Freeview.   Powered by

Badges  |  Report an Issue  |  Terms of Service