Hi

Recently installed the 8200 all works fine, but I'm replacing a TopField that switched between two LBNs so I could view BVN on the D2 sat.  (So one cable coming down with the switcher close to the dish, worked great with the TopField)

Can you help me find out how to do this on the 8200 (if it can) I don't find the manual very helpful I can see the LBN setting but don't know which are appropriate)

I can see the D2 and when blind searching it shows a lot of assets but not in vertical mode, I also don't know how to bring up D2 after the search.

I'm aware that recording will be limited to one LBN at the time but would still like to be able to life view.

Views: 117

Reply to This

Replies to This Discussion

I believe you need to turn the 22khz switch to ON in the LNB setup screen.


Thanks Paul

I think I tried that once but will try again tonight, keep you posted.

Cheers

C


Paul said:

I believe you need to turn the 22khz switch to ON in the LNB setup screen.

Hi Paul

Got it to work, only problem is once it's switched over to the other LNB (D2 Vertical). It refuses to switch back to the other LNB that runs the the standard freeview channels.

I have to connect modish up to the Topfield to do the switchback and then things come right.

But of course I lose the D2 link again. Do I need a different switch box?

Hi Chris

Try turning on DiSEqc & Tone burst and see if that makes any difference.



Chris Verburg said:

Hi Paul

Got it to work, only problem is once it's switched over to the other LNB (D2 Vertical). It refuses to switch back to the other LNB that runs the the standard freeview channels.

I have to connect modish up to the Topfield to do the switchback and then things come right.

But of course I lose the D2 link again. Do I need a different switch box?

Remember it is designed for Freeview with freeviews middleware as opposed to being a FTA receiver with no middleware , my thoughts would be that it won't be reliable on the non Freeview channels may get dumped when a Freeview update is applied , do let us know how you do , you maybe better off with a stand alone box on D2 (a FTA one)

Thanks Robert

Got it work and see both satellites but BVN is invisible in the programme selector on the 8200.

For now, I have looped in the 8200 via the old Topfield and that does work, just a lot of messy switching (not spouse friendly) 
As expected the 8200 freezes up when switching to the other LNB, but when recording at the same time the recording carries on (can't quite get my head around that)

For the future I might wan't a update for the TopField that can record D2 separately, any brands/models come to mind?


Robert Hepple said:

Remember it is designed for Freeview with freeviews middleware as opposed to being a FTA receiver with no middleware , my thoughts would be that it won't be reliable on the non Freeview channels may get dumped when a Freeview update is applied , do let us know how you do , you maybe better off with a stand alone box on D2 (a FTA one)

Reply to Discussion

RSS

Connect With Us!

Latest Activity

Karyn Jensen replied to Karyn Jensen 's discussion Dish S7070
"Definitely S7070 :-)"
7 hours ago
Paul replied to Karyn Jensen 's discussion Dish S7070
"Is it a S7070 or S7070r ?"
8 hours ago
Karyn Jensen replied to Karyn Jensen 's discussion Dish S7070
"Thanks for the info. The signal and strength are both showing 0% when normally it shows at about 78%"
9 hours ago
Biggles replied to Patricia Harkins's discussion Which Freeview recording box?
"HTPC = Home Theatre PC. Usually a low cost small footprint silent box. No fans to make noise while…"
14 hours ago
Biggles replied to Karyn Jensen 's discussion Dish S7070
"Check your signal strength in the Tuning Menu too. My Sat receiver shows around 56% signal and 40 -…"
14 hours ago
Patricia Harkins replied to Patricia Harkins's discussion Which Freeview recording box?
"Thank you so much for the advice, appreciated. I am not familiar with HTPC but shall look into it.…"
14 hours ago
Biggles replied to Patricia Harkins's discussion Which Freeview recording box?
"Never had any problem with my Panasonic recorders. On the other hand the DishTV and others seem to…"
14 hours ago
Paul replied to Karyn Jensen 's discussion Dish S7070
"The Lnb may have started to drift , try doing the below. S7070 LNB Drift    To…"
16 hours ago

Upcoming Works

© 2017   Created by Bel.   Powered by

Badges  |  Report an Issue  |  Terms of Service