Hello

I recently moved house and gone from UHF to a satellite area. I have purchased a dish tv S8200 but and having trouble getting freeveiw. The satellite has a universal double LNB and I am getting some scramble sky channels listed but no FTA channels.

Views: 144

Reply to This

Replies to This Discussion

Was the dish known to be working before you moved in? If not then it could be a failing LNB.

Have you set the LO to 10600 ?
you mean 10750 tone/22khz off
No I mean 10600

Why 10600? Std LNB are 10750 or 11300. Never seen a 10600 one.

John Baird said:

No I mean 10600

I was getting signal in the universal band, which I thought was a bit weird and getting scrambled sky.

I had a look at the dish next door and it is setup the same.

I jumped up last night to have a look at alignment and found it is a 10750 LO, and not in the universal range so alignment is out.

The cable out on the LNB was down at about the 6.30 Mark so I twisted it around to about the 8 o'clock Mark and now getting freeveiw. 

Why 10600? Std LNB are 10750 or 11300. Never seen a 10600 one.

He said he had a universal LNB Biggles and that is the frequency needed to make it work



Biggles said:

Why 10600? Std LNB are 10750 or 11300. Never seen a 10600 one.

John Baird said:

No I mean 10600
Biggles,
A Universal LNB usually receives the signal in both the Low and High Sat bands. They have two oscillator frequencies to allow access to the bands. More common ones are 950/10600 with the 22KHz tone switching between the two oscillators. These LNBs are common in the EU as they have satellites that transmit in the low and high sat bands. To get to the high sat band, where the Freeview signal is at the moment, a setting of LO=10600+22KHz ON is necessary.

Reply to Discussion

RSS

Quick Tools

Latest Activity

James Eaton replied to James Eaton's discussion Sound problems on all TVNZ channels
"This may be an intermittent problem there have been several reports from others on the Neighbourly…"
9 hours ago
Philip Lodewick Olivier replied to Philip Lodewick Olivier's discussion Problems with Dish TV s7070r decoder.
"Followed some of the advice on this forum and did a "Factory Default" reset, tried again…"
10 hours ago
James Eaton replied to James Eaton's discussion Sound problems on all TVNZ channels
"So it is all fixed now. (19:00)"
11 hours ago
James Eaton posted a discussion

Sound problems on all TVNZ channels

Transmitter is Ngarara in WaikanaeOnce again the sound is out of sync with the video on TVNZ…See More
13 hours ago
Maureen Seth replied to Maureen Seth's discussion aerialBox-mini T1000 no longer working
"Thanks for your advice. I decided to upgrade to the T2200 anyway. I think the T1000 has had it."
17 hours ago
Maureen Seth replied to Maureen Seth's discussion Receiver or Recorder?
"Thank you, Josh. I went ahead and bought the T2200, & am very happy with it."
17 hours ago
Philip Lodewick Olivier posted a discussion

Problems with Dish TV s7070r decoder.

Have a problem with my daughter's decoder. I disconnect my decoder (Veon 101) and replace it with…See More
19 hours ago
Josh Hill ✔️ replied to Maureen Seth's discussion aerialBox-mini T1000 no longer working
"Dish TV are the people to go to for support about that particular device. They will be able to…"
yesterday

Connect With Us!

© 2018   Created by Bel.   Powered by

Badges  |  Report an Issue  |  Terms of Service