Devices covered in this post: On some STRONG UNITS or any receiver that shows the following similar display by pressing the menu.

This is the Menu display: Check to see if you have the same type or display if you do then follow the next steps with photos! If not then you may be able to follow the instructions but display may differ on Strong units. 

Step 1
On your remote press Menu  

Use the arrow keyS to select Installation 

Then use the right arrow key to select the 2nd column and then select Manual Scan

--------------------------------------------------------------

Step 2
On your remote press the GREEN BUTTON  

-------------------------------------------------------------

Step 3
You will receive a blank entry base e.g. 

Move on to the next step: >>>>>

-------------------------------------------------------------

Step 4
Please enter the following information as shown on the picture above 

Frequency: 12519 (Ignore the 35 shown on the beginning of the line)

Symbol Rate: 22500

ONCE DONE PRESS THE OK BUTTON TO START A SCAN. IT WILL SCAN FOR THE CHANNELS.

-------------------------------------------------------------

Step 5

After the scan keep pressing Menu until you return back to a TV Channel. 

Press OK to open a channel list up 

channel will appear  on the bottom of the list

-------------------------------------------------------------