I have the programme guide for Maori TV, but when I change to the channel I get "No Event Information"

When I try to set a programme to record using the "Guide" button I get an error saying "This programme cannot be booked at this time. Please try again later. (code - 2)

Can someone contact Maori TV and get them to fix this please

Views: 103

Reply to This

Replies to This Discussion

Or you could just use Timer Record instead.

This happens quite a lot and is usually fixed with the next EPG update.


I thought about that and - do you know what? I couldn't be bothered and used On Demand instead.


Biggles said:

Or you could just use Timer Record instead.

This happens quite a lot and is usually fixed with the next EPG update.

Hi

Maori TV has been making changes to their broadcast, you can try a factory default on the unit to try to correct this as this will force the unit to collect the latest EPG data. Factory default can be done in the menu - installation - factory default, the password to do this is 0000. You just need to press the OK button on the welcome screen that comes up to get it to scan the channels again. If this problem persists please contact our support desk, support@dishtv.co.nz

-Luke


Thanks Luke - I may give it a few days to see if it gets fixed as a Factory Reset will loose all my recording settings and I would have to set them up again.


Dish TV Support said:

Hi

Maori TV has been making changes to their broadcast, you can try a factory default on the unit to try to correct this as this will force the unit to collect the latest EPG data. Factory default can be done in the menu - installation - factory default, the password to do this is 0000. You just need to press the OK button on the welcome screen that comes up to get it to scan the channels again. If this problem persists please contact our support desk, support@dishtv.co.nz

-Luke

Maori Television and Te Reo have moved multiplexes and some receivers aren't reflecting the new location of the services and are still pointing to the old one. You'll need to do a rescan to force the receiver to pick up the new services.

Reply to Discussion

RSS

Quick Tools

Latest Activity

Biggles replied to Sue Hutchings's discussion Loss of Channels
"Antenna looks OK. Same as mine. Pg 37/38 of the Manual, not…"
yesterday
Sue Hutchings replied to Sue Hutchings's discussion Loss of Channels
"The aerial...tah dah!!!  I have gone into the menu and can't find a page 38????"
yesterday
Sue Hutchings replied to Sue Hutchings's discussion Loss of Channels
yesterday
Biggles replied to Sue Hutchings's discussion Loss of Channels
"OK. Check signal strength for each MUX in the T2200 setup menu and post results. Pg38 of the Manual…"
Friday
Sue Hutchings replied to Sue Hutchings's discussion Loss of Channels
"Thanks for reply! It is an outside UHF aerial. What sorts of things can cause interference, do you…"
Friday
Biggles replied to Sue Hutchings's discussion Loss of Channels
"What sort of antenna do you have? Sounds like an antenna/cabling problem as you are missing justone…"
Friday
Sue Hutchings posted a discussion

Loss of Channels

Hi everyone...I hope someone can help me.I recently purchased a Dish T2200 and installed it without…See More
Friday
nzdtv.com replied to John Ridgway's discussion YAGI-type UHF Aerial in the sitting room?
"The only health issue is if you trip over it, Heres a tip for indoor use of a outdoor antenna you…"
Thursday

Connect With Us!

© 2017   Created by Bel.   Powered by

Badges  |  Report an Issue  |  Terms of Service