Hi. Just trying to install a new T2200 Freeview Plus. All good except connecting wirelessly to Internet. Seemed to work but won't now. I get " connected" and then it verifies status, and I get " Unavailable"????? My iPad and phone work fine nearby. Signal strength shows as 54%. Would I be better off with a Powerline adapt apt and wire it? Frustrating so any advice would be appreciated.
Finally, is a Factory Reset the way to go. Cheers

Views: 235

Reply to This

Replies to This Discussion

Hi Paul 

Dish TV recommends unplugging the device from the wall and then plugging it in again and then see if the device boots up with the internet connection going, that might help the internet issue you are experiencing, if you are still having issues please reply

Regards, Josh  

Hi there. Thanks Josh. Tried that. Called Freeview Help desk and , in discussion, they said that a modem strength (as received by the T2200) needs to be in the order of 70%+ (mine is about 54%) to avoid this problem. I shall persevere, but if it doesn't sort itself out, I shall buy a Powerline Adapter Kit-which I'm advised works very well. (Hard wiring it would be a major mission.) Cheers

I am also struggling with this issue. One minute it works then stops again. Very frustrating. I have powered down the modem and t2200 many times but issue is still there.

Had you thought about trying one of these WiFi extenders?

https://www.pbtech.co.nz/product/NETTPL2841/TP-Link-TL-WR841N-300Mb...

It is probably much more sensitive than the STB's built in WiFi. Just locate near the STB and connect using WiFi or cable. The extender would provide much more reliable connection to the Modem/Router than the STB by itself. I tested a similar one here and it worked quite well. My main Modem is upstairs and signal strength downstairs is not great. I located the extender on the TV cabinet and it connected wirelessly to the main modem OK. Once connected I was able to wirelessly connect reliably other equipment to the extender throughout the rest of the house. There's also other extenders that just plug into a convenient power point. They work well even at low signal strength. Until recently I didn't even know they were available and how they worked.

Reply to Discussion

RSS

Quick Tools

Latest Activity

James Eaton replied to James Eaton's discussion Sound problems on all TVNZ channels
"This may be an intermittent problem there have been several reports from others on the Neighbourly…"
19 hours ago
Philip Lodewick Olivier replied to Philip Lodewick Olivier's discussion Problems with Dish TV s7070r decoder.
"Followed some of the advice on this forum and did a "Factory Default" reset, tried again…"
19 hours ago
James Eaton replied to James Eaton's discussion Sound problems on all TVNZ channels
"So it is all fixed now. (19:00)"
21 hours ago
James Eaton posted a discussion

Sound problems on all TVNZ channels

Transmitter is Ngarara in WaikanaeOnce again the sound is out of sync with the video on TVNZ…See More
23 hours ago
Maureen Seth replied to Maureen Seth's discussion aerialBox-mini T1000 no longer working
"Thanks for your advice. I decided to upgrade to the T2200 anyway. I think the T1000 has had it."
yesterday
Maureen Seth replied to Maureen Seth's discussion Receiver or Recorder?
"Thank you, Josh. I went ahead and bought the T2200, & am very happy with it."
yesterday
Philip Lodewick Olivier posted a discussion

Problems with Dish TV s7070r decoder.

Have a problem with my daughter's decoder. I disconnect my decoder (Veon 101) and replace it with…See More
yesterday
Josh Hill ✔️ replied to Maureen Seth's discussion aerialBox-mini T1000 no longer working
"Dish TV are the people to go to for support about that particular device. They will be able to…"
yesterday

Connect With Us!

© 2018   Created by Bel.   Powered by

Badges  |  Report an Issue  |  Terms of Service