I am intending to split the feed from the current Sky decoder to a satellite box in another room. From what I have read here it is relatively straightforward to split the dish feed with a power pass splitter on the sky (primary) port which maintains power to the LNB  , and the other port to the freeview box which doesn't have to be power-pass and as long as the primary Sky decoder is left switched on - no problem. An all-ports power-pass splitter could be used , but it is recommended that LNB power be set to "OFF" on the freeview box. I already had a splitter for another purpose and need to identify if it is a single-port power pass type. There are no labels etc but has a line drawn between the IN port and 1 of the OUT ports. I'm fairly certain this is a single. (pic attached). Could someone please just confirm ? .

Views: 183

Reply to This

Replies to This Discussion

Good Afternoon Robbo

This is a single port power pass splitter but it only is rated to 900MHz which is to low to work for satellite signal but ok for terrestrial 

Thankyou John ... exactly what I needed ... superb. I did wonder about the low number ...cheers I will go and buy another.

Robbo as per a previous post these are the splitters that I use the bigger of the 2 has 4 freeview and 1 sky box rnning through them I apoligise for the poor quality of the last image but you should be able to see what I mean't .

Attachments:

Reply to Discussion

RSS

Latest Activity

Biggles replied to John Kirkbride's discussion TV 3 6PM News Recording Problem
"My Panasonic did the same recently and has also done so occasionally in the past. Was set to record…"
4 hours ago
Cliff Baker replied to Jared's discussion tvnz ondmend
"I think the previous firmware was actually 3.925 from October 2017 so you hadn't missed out on…"
6 hours ago
John Kirkbride posted a discussion

TV 3 6PM News Recording Problem

Have a couple of Panasonic DVR's and have had recurring problems since 2013 with recording the news…See More
6 hours ago
David B replied to Jared's discussion tvnz ondmend
"It's a 43W800C"
8 hours ago

Connect With Us!

© 2018   Created by Bel @ Freeview.   Powered by

Badges  |  Report an Issue  |  Terms of Service